The large display that is designed for use with the medical pedal exerciser comes with a AAA battery.
The installation can be done in a few steps.
1. Remove the Battery Cover
Remove the battery cover to your LCD large display by gently pressing down on the clasp. The clasp will release and remove the cover.
2. Insert New Battery
* Remove plastic wrap from battery if applicable.
The lip enclosure for the battery is snug. To insert the battery place the negative (-) end toward the spring.
The battery should be marked with (-) and (+) on each end of the battery.
If not; the (+) end of the battery is the one with the tip and the negative end (-) is the flat end.
Set the battery on an angle so you can slide the battery in between the two lip enclosures.
Gently press the battery toward the spring and the plastic lips will part to allow a snug fit.
When the battery is completely slid to the spring, press the battery down to put in place.
Replace Battery Cover
The battery cover is replaced by:
First line up the slots on the bottom side of the cover
and gently slide into place.
Once the cover is square you can close the top side and gently press the clasp to clip into place.